Remove debris from your skimmer and pump baskets. … Skim your pool to remove any debris on the water’s surface, including bugs.Brush and vacuum your pool.Lower the water level if needed.

What do you do with your pool after heavy rain?

• Remove debris from your skimmer and pump baskets. …
• Skim your pool to remove any debris on the water’s surface, including bugs.
• Brush and vacuum your pool.
• Lower the water level if needed.

How do I lower my pool?

Approaches on How to Drain a Pool For inground pools with a sand or DE filter, the easiest way to quickly lower the water level is to place the multiport valve into the waste position and roll out the backwash hose. If instead, you have a slide (push-valve), backwash the filter to lower the water level.

What happens if pool water level is too high?

If the water level is too high the debris floating next to the opening may pass by without being pulled into the skimmer. However if the water level is too low it may cause the skimmer to suck air into the system. If this happens you may run the risk of burning up your pool pumps motor.

What happens if above ground pool overflows from rain?

But large quantities of precipitation combined with an overflowing pool and poor drainage can cause problems such as flooding, structural damage to the surrounding buildings as well as out of balance swimming pool water chemistry.

Do pools overflow when raining?

The pool will only overflow by the amount of rain in excess of the amount of rain needed to fill the pool to the top. … Pools that are empty can “POP” out of the ground, floating like a boat on the groundwater around your home.

Should I shock my pool after heavy rain?

Shock & Filter the Water Shocking helps sanitize any contaminants or materials that were introduced to the water during the storm. Run your system for at least 12 hours to ensure proper filtration and circulation. This removes dirt and debris, and also assists with circulating the chlorine throughout your pool.

How do I know if my pool is too full?

If you get more than five inches of rain in an hour, or if your pool wasn’t properly designed with sufficient overflows, then your pool may overflow, which can put you at risk of water getting inside of your home and causing serious damage.

How do I lower the water level in my above ground pool?

1. Start with your pump OFF.
2. Open the two-way valve if there is one.
3. Move the multiport valve to “WASTE”.
4. Turn the pump ON and run until you reach the desired water level.
5. Turn the pump OFF.
6. Move the multiport valve back to “FILTER”
7. Close the two-way valve if there is one.

Can an above ground pool be overfilled?

Above Ground Pools One of the most common concerns some people have is that the walls may begin to have too much pressure and weight from the excess water. There could be a few reasons when it may become a reasonable issue, but in most cases you should be fine.

Article first time published on

How do I stop my above ground pool from overflowing?

The best measure to keep your pool from overflowing and causing damage is to make sure that your yard drains properly; try running a hose to see where the water runs to and how fast. Make sure the deck is pitched slightly away from the pool to keep contaminants flowing out of your pool rather than into it.

Where is the overflow drain on a pool?

Swimming pool builders often install overflow drains near the rim of the pool that prevent flooding most of the time. If you don’t have an overflow drain, or if it is clogged, it is possible for periods of unusually heavy rain to overflow your pool.

Should you cover pool when raining?

When preparing your pool for a storm, leave it uncovered. Installing any kind of cover across the pool will not do much to protect against dust and contaminants because storms often bring strong winds and heavy rain that can cause the cover to lift off your pool.

Does rain lower chlorine levels?

Rainfall dilutes pool chemistry levels and lowers the readings for pH, alkalinity, hardness, stabilizer, and chlorine. Rainfall does not contain chlorine.

How can I drain my pool without flooding the yard?

1. Unroll the pump’s intake hose so that it reaches the center of the pool (or as close to it as possible), and submerge it in the pool.
2. Place the outlet hose so the exiting water doesn’t flood the area, but drains off away from the pool.
3. Dry your hands thoroughly.

How do I get water out of my pool without a pump?

1. Place one end of a water hose in the pool. …
2. Take the other end of the hose to where you want the water to drain. …
3. Siphon the water out of the pool by placing your mouth on the end of the hose and sucking repeatedly until water comes out.

How long does it take for a pool to drain?

Draining a pool can take up to 14 hours, depending on the size, so be sure to drain it on a day when you have sufficient free time. You need to be home to check on the pool, the hoses, and the pump frequently. Do not let the pump run dry or it can become damaged.

What should my pool levels be?

The recommended level for swimming pool water is 80-120 ppm. When pool water is found to be low in alkalinity (below 80 ppm) it is recommended that this level be increased.

How do I lower the water level in my pool sand filter?

For most pools with a sand/glass media or DE filter, the simplest way to lower the water level is to place the multiport valve onto the waste position and roll out the backwash hose. If you have a slide (push-pull) valve, backwash the filter to lower the water level.

How do you drain an above ground pool below skimmer?

Turn the filter off (or unplug it) and set it to Waste. Shut off your skimmer and open your pool’s main drain. Turn your filter on and the water will start to pump through your backwash hose. Allow the water to drain.

Do I need to drain pool below skimmer?

It’s acceptable to drain the pool a few more inches below that if you live in an area that gets heavy precipitation during the winter months. Some pool professionals even suggest draining the water to as much as 6 inches below the skimmer — about the level of the bottom of the pool’s return jet.

Should I run my pool pump during a storm?

At the first sign of an incoming storm, you should turn off and unplug your pump. If this is left running during a storm, the motor may suffer electrical damage and short out. … These items should be secured in a safe place to prevent damage and to ensure that they are not blown away in the storm.

Can you overfill an Intex pool?

To the line near the bottom of the inflated ring. Do Not Overfill above the line as this may cause the pool walls to become unstable and possibly result in injury or property damage from the water flowing over the pool wall while in use.