Press the rubber primer bulb on the side of the mower engine three times. … Pull and hold the safety bar near the top of the handle. … Grip the handle of the starter rope and pull with a rapid movement. … Place the ignition key in the keyhole on the Toro lawn mower.

How do you start a Toro lawn mower?

1. Press the rubber primer bulb on the side of the mower engine three times. …
2. Pull and hold the safety bar near the top of the handle. …
3. Grip the handle of the starter rope and pull with a rapid movement. …
4. Place the ignition key in the keyhole on the Toro lawn mower.

How do you start a self propelled lawn mower?

Stand behind the lawn mower. Use one hand to hold the engine stop lever in the operating position. Use the other hand to hold the recoil starter handle. Slowly pull the recoil starter handle until resistance is felt, then pull quickly to start the push mower engine.

How do you start a lawn mower step by step?

1. Step 1: Position the lawn mower. …
2. Step 2: Check the petrol level. …
3. Step 3: Check the oil level. …
4. Step 4: Check the spark plug. …
5. Step 5: Press the fuel button 3 to 5 times. …
6. Step 6: Put the throttle in the start position. …
7. Step 7: Pull the starter rope. …
8. Step 8: Lawn mowing!

Where is the choke lever on a lawn mower?

There’s a variety of lawn mowers, but for an internal combustion engine, the choke valve is usually located on the body of the engine or a lever on the handle. Most choke valves are butterfly valves mounted in the manifold up from the carburetor jet.

How do you start a lawnmower without a primer?

In order to start your mower without a primer, squirt starter fluid directly into the carburetor via the air intake. Simply remove the air filter cover, take out the air filter, and squirt starting fluid into the air intake nozzle. Quickly replace the air filter, and start your mower. It should start straight away.

What would cause a Toro Zero Turn not to start?

Check the PTO switch is in the “Off” position. These safety components on the Toro mower must be in the proper positions or the engine will not start. Check the oil level in the crankcase, located on the top of the motor. … If it is torn or damaged, replace it with a new filter recommended for your Toro model.

How do you charge a electric start lawn mower?

Plug the charger into a standard 120 volt power outlet and let the battery charge for 8 ~ 24 hours. The charger may become slightly warm during charging, this is normal. Do not use an automotive style battery charger to charge the battery. Do not charge the battery for more than 24 hours or the battery may be damaged.

How do you start a Toro Recycler 22 gas?

Pull the starter handle if the mower is a gasoline-powered model; pull the starter handle slowly until you feel resistance, and then pull it with sharp force. Let the starter handle return to its former position slowly. Repeat pulling the starter handle until the mower starts.

Does the Toro TimeMaster come with oil?

Important: This machine does not come with oil in the engine. Before starting the engine, fill the engine with oil.

Article first time published on

How do I start my lawn mower with a choke?

Open the choke all the way if you notice that it has been closed. If it has been open, the carburetor may be flooded. Close the choke, and pull the starting cord a few times. When you get the engine to sputter, open the choke, and try starting the mower.

How do you start a stubborn lawn mower?

Turn the choke off after a few attempts and try again. Give the spark plug wire a little tug to see if it’s loose. If it is, push it onto the plug and try starting the mower. If there isn’t any difference, remove the plug with a spark plug wrench and clean the gap with an emory board.

Can you push start a self propelled lawn mower?

You can push a self-propelled lawnmower, it won’t damage the transmission in any way. However, it may be difficult to do so, self propelled mowers are a little heavier than a regular push mower. … Pushing a self-propelled mower is tough work, especially on a hot day.

How do you start a new lawn mower?

1. Unbox Your Mower. …
2. Adjust the Handle. …
3. Install the Battery (Cordless Electric Mowers) …
4. Add Oil (Gas-Powered Mowers) …
5. Fill the Fuel Tank (Gas-Powered Mowers) …
6. Check the Spark Plug (Gas-Powered Mowers) …
7. Inspect the Wheels and Adjust the Height. …
8. Attach the Bag, Mulch Plug, or Discharge Chute.

Why is my lawn mower turning over but not starting?

The most common reason for a riding mower cranking over but not starting is bad gas, but other possible reasons include: Gas Valve Off. No Gas. Choke Fault.

How does a choke work on a lawn mower?

By restricting the flow of air into the throat of the carburetor, the choke valve reduces the pressure inside the throat, which causes a proportionally greater amount of fuel to be pushed from the main jet into the combustion chamber during cold-running operation.

Where is the spark plug on a lawn mower?

Spark plugs are typically located on the back or side of a lawn mower engine. Look for a short wire that’s about 1/4-in. -thick leading to the top of a short, cylindrical protrusion from the engine. If you’re not sure where the spark plug is, consult your owner’s manual.

How do I drain the gas from my lawn mower?

One way to remove the gas is to use either a hose to siphon off the gas or a baster/pipette to remove the gas from the lawn mower gas tank to a gas can. Alternatively, the fuel line connecting the fuel tank to the carburetor can be disconnected at the carburetor and fuel emptied into a gas can.

Do Toro lawn mowers have spark plugs?

You probably know that this little plug produces the powerful spark that starts your mower. … Your local Toro service dealer is the best place to get the correct replacement spark plug for your machine. Bring your machine’s model and serial number so you’re sure to get the right plug.

How can you tell when a spark plug is bad?

1. Rattling, pinging or “knock”-like noises. When spark plugs begin to misfire, you may notice unusual noises from the force of the pistons and combustion not working properly. …
2. Hard vehicle start. …
3. Reduced performance. …
4. Poor fuel economy.

What does a spark plug tool look like?

The most important tool is a socket wrench with an extension and a spark plug socket. Spark plug sockets come in two sizes: 5/8 inches and 13/16 inches. Most spark plug sockets have a rubber insert that holds the plug snugly in place. You may also need a universal joint if your spark plugs are difficult to reach.

Why does my Toro riding lawn mower not start?

Clean the fuel filter and check for adequate flow from the fuel lines. Clean or replace the air filter. Clean or replace the spark plug, making sure the spark plug gap is correctly set (specific gap may be found in the user manual). Make sure the spark plug wire is firmly attached to the spark plug.

Where is primer button on lawn mower?

Locate the primer bulb on the side of the lawnmower engine. The primer bulb is usually red and located under the carburetor.

Why does my mower not have a primer bulb?

When the primer bulb isn’t working, it may be a problem with the bulb itself, with the fuel lines that feed fuel to the bulb or both. … When they’ve hardened and cracked, they let in air, which makes it impossible to draw the fuel into the carburetor properly.

Do all lawn mowers have a primer bulb?

Things You’ll Need Most small engines use a primer bulb. A carburetor on a lawnmower is very small compared to the larger ones commonly found on older automobiles. Because of this, carburetors used on small engines usually have a rubber or plastic priming bulb that forces fresh gas into the carburetor bowl.