Turn on the ignition switch with your car key. … Wait for the airbag warning light to turn off. … Turn the ignition switch of your car back off for a little longer than three seconds.Repeat steps 1 through 3 twice to make three times total.

How long should the airbag light stay on?

The SRS light should come on for seven seconds, and then shut off and stay off. The airbag light has been reset. If you continue to drive your vehicle with the SRS light illuminated, you may risk an accidental deployment of the airbag.

How much does it cost to fix the airbag light?

Number 1 — Reset Airbag Light You’ll need to hire a professional to come in and examine the airbags before you continue to drive the car. This process can take several hours of time and usually costs a few hundred dollars, although depending upon the type of car it may be up to about $600.

Will my airbag light go off?

If your vehicle—and airbag system—is working properly, the light should remain off. Or, in some vehicles, it may turn on for a few seconds along with all other displays and then immediately dim out. This is normal. If the light persists, however, this is when you should get your airbag system looked at!

How do I know if my airbag sensor is bad?

Symptoms of a failing airbag sensor You can easily tell if the sensor is functioning if the airbag warning light on the dashboard is illuminating every time you start the vehicle. But, if the airbag warning light stays illuminated after starting the vehicle, this is an indication of an airbag sensor problem.

Where is the airbag sensor?

An impact sensor is normally fitted to the front of the vehicle as this is where a collision is likely to occur. The sensor is positioned inside the engine and a similar safety sensor is located inside the passenger zone of the vehicle.

Can airbag light be reset?

An airbag warning light can not turn itself off and has to be manually reset. When an airbag light comes on, there is something wrong with the airbag system. … Nevertheless, you will need to manually reset the airbag system after you fix the problem.

How do I fix my airbag light?

1. Turn your ignition on and off.
2. Restart your vehicle and do a test drive.
3. Examine the passenger airbag switch.
4. Inspect whether seat belts are fastened or working correctly.
5. Verify that the passenger seat sensor is not applied.
6. Use a scanner with an SRS or airbag light reset option.

Can I drive my car with the airbag light on?

The bottom line is that, when your airbag light comes on, it’s vital that you don’t drive any further and have your car checked by a mechanic as soon as possible. Until the problem is diagnosed and fixed, your airbags will not deploy.

Can you drive without an airbag?

Will I be able to drive without airbags? If your question is about the car being able to move even without airbags, the answer is yes. Airbags have nothing to do with the engine and overall functionality of the car, so technically you will still be able to drive your car even without airbags.

Article first time published on

What could cause the airbag light to come on?

The most common cause for the airbag light coming on is that the airbag system is deactivated or turned off. … There may be an issue with a crash sensor, SRS module, or other airbag component. Alternatively, the sensor in the passenger seat that determines whether that airbag should be active or not may be faulty.

How much are airbag sensors?

The average airbag sensor replacement cost is between $100 and $600, depending on the car model and labor costs. An airbag sensor costs $50 to $300 and a labor cost of $50 to $300.

Why do airbag sensors fail?

The airbag clock spring is there to maintain continuity between the electrical wiring of the vehicle and the driver-side airbag. It coils in and out as the steering wheel turns. It can become worn out naturally over time, which causes a poor connection and potential airbag failures.

Is there a fuse for airbag light?

One fuse in particular, fuse #13 is a likely culprit. If your airbag light is on and your rear windshield wiper doesn’t work, then it’s a pretty good indication that you need to change fuse #13 and possibly others. Blown fuses can definitely cause the airbag light to come on.

Can you reset airbag light without tool?

In some older cars, though, it is possible to reset the airbag light without a scanner by removing the car battery terminals. Check the wiring system underneath the driver or passenger seat for any loose wires or corrosion in the connector plug. Spray the connector plugs with an electronic cleaner and restart your car.

Will airbags deploy with SRS light on?

You should never ignore the vital warning. While it doesn’t mean the car is unsafe to drive, there’s no reason to take chances with it. However, the light does indicate that the SRS components are not working as they should. This could also mean that the airbags won’t deploy if an accident occurs.

Can low battery cause airbag light?

Another common problem could be a bad ground to the battery that causes warning lights to turn on (including the airbag light). It can if the battery is at 9V or below. Often the light will extinguish after the battery returns to normal voltage.

Can you replace a deployed airbag?

It is imperative you have a mechanic replace the airbags in your vehicle after they deploy and before you drive the car again. Replacing an airbag requires special skills. The technician must remove the entire airbag module and replace it with a new one.

Can you have a steering wheel without airbag?

Answer: There is no law specifically related to steering wheel size. … It would be unsafe to replace the original steering wheel with one without an airbag. Vehicle airbags are designed to work with the installed seatbelts to keep all the occupants safe in the event of a crash or rollover.