For the most authentic look, we recommend measuring only the window opening not including any frame or trim around it. Typically, the width of your shutters should be half of your total window width.

How do you know what size shutters to buy?

For the most authentic look, we recommend measuring only the window opening not including any frame or trim around it. Typically, the width of your shutters should be half of your total window width.

How do you measure and install indoor shutters?

Measuring for Inside Mount Plantation Shutters Measure the inside width of the window in three locations, as shown in illustration A: top, middle and bottom. Always measure the opening at the point of the window where the shutter frame will be installed. Record the narrowest width of the three.

How wide should shutters be on a house?

The width that usually works best for decorative shutter is between 25% and 33% of the total width of your window including the window trim. … If you prefer to make your exterior shutters look operable, find a width that is close to 50% of the size of the glass and the window frame only, excluding the window trim.

Should all exterior shutters be the same width?

We recommend a shutter width about 1/3 of the window. As a general rule try to keep all the shutter widths uniform as this will give you a much cleaner overall appearance but there are always exceptions to any rule.

How do you measure for functional exterior shutters?

Measure for the shutter height at the left side, middle, and right side of the window opening from the top of the window to the bottom excluding any window sill. If the heights vary at each of these points, use the smallest of the three measurements. This measurement will be the height of the shutter you need to order.

Do exterior shutters add value to your home?

With exterior shutters, you can improve your home’s value and a lot more. This window treatment technique protects your house, boosts energy efficiency, and improves curb appeal. Shutters also enhance privacy and help transform the exterior décor.

Can you put shutters on double windows?

Shutters should be avoided on double-mulled windows, picture windows, bay windows, and most dormer windows.

How far should shutters be from window?

In most cases, the height of decorative shutter that is most appropriate is from the top to the bottom of the window trim. If there is a sill at the bottom of the window and you are installing vinyl shutters, it is important to leave a gap of at least 1/4 inch to allow the vinyl material to expand and contract.

Should shutters be longer or shorter than window?

Since vinyl shutters don’t have that much flexibility in terms of shutter width, it is best to err on the side of the exterior shutters being narrower than 50% of the window width. In most cases, the height of decorative shutter that is most appropriate is from the top to the bottom of the window trim.

Article first time published on

Do shutters go on back of house?

If you want to amplify your home’s style, then adding shutters to the back is a no-brainer. It’s an especially easy choice when you think about all the other benefits that functional exterior shutters can provide. The choice to put shutters on the back of your home is a personal one.

Do shutters make a house look smaller?

Shutter colors for beige house White shutters, if matched to your window trim, can make a smaller house appear larger. Black shutters can especially pop on larger homes. Think of other dark colors, too.

What size do plantation shutters come in?

When purchasing plantation shutters the most important option is the louver size. Shutter louvers or slats come in 1 7/8″, 2″, 2 1/2″, 3″, 3 1/2″, 4″, 4 1/2″, 5″ and 5 1/2″. Depending on style, view or architectural feature you’re looking for, louver size is often a personal preference.

How much depth do plantation shutters need?

Minimum depth for inside mounts is 2 ½” from glass to the outer edge of the window frame. Shutters with a 3 ½” louver require a minimum depth of 3”. For best results, inside mounting is recommended for shades that will be installed on window frames with at least a 2 ½” minimum depth.

How wide can a single plantation shutter be?

However, this width can only be made in a single shutter. Wooden shutters can be made in a width up to 1047mm with 89mm louvres. If you need two or more panels bi-folding together the maximum guaranteed width for any shutter is 550mm per panel. For wooden shutters, this width increases to 660mm per panel.

How wide should board and batten shutters be?

Building Board and Batten Shutters Go ahead and cut all of your boards to length on a miter saw, and then make any rips that you need to accommodate the width of your window. … Each batten will run diagonally across the boards and should be just shy of the width of your shutter.

How thick should shutters be?

Shutter stiles shall be a minimum of 2-5/8 inches wide by 1 3/8 inches thick. Top rails and midrails shall be a minimum of 2 3/8 inches wide by 1 5/16 inches thick. Bottom rails shall be minimum 4 1/8 inches wide by 1 3/8 inches thick.

How much do outside shutters cost for a house?

National Average$692Typical Range$301 – $1,083Low End – High End$135 – $2,400

Why do houses have fake shutters?

They protect against storms or other inclement weather. The provide relief from the hot summer sun and cold winter winds. They keep rain, hail, sleet and snow off your windows, and extend their life. They can provide privacy or help to darken a room for sleep.

How much does it cost to put shutters on a house?

Window SizeShutter Price72”x96”$1,140

What kind of wood should you use for exterior shutters?

Cedar is the most commonly used wood as a material for creating exterior shutter. Not only shutters, but cedar wood is also actually used for many exterior applications. The chief reason for using cedar is that it’s dimensionally stable. This means it’s resistant to warping and twisting.

How do you measure the offset of a shutter?

FOR CASE-MOUNT HINGES: Measure from the casing (B) to the back of the wood (A). This dimension is considered your offset and is used when selecting hinge offset. FOR JAMB-MOUNT HINGES: Measure from the back of the inside edge of the casing (C) to the back of the wood (A) and then add the thickness of the shutter.

Are exterior shutters outdated?

Today, shutters are used extensively all over the world, for functional and aesthetic purposes. Do all houses need shutters? Absolutely not, and many, many houses would look much better without shutters, rather than with “today’s” shutters.

How do I stop my shutters from closing?

Adjusting Louver Tension Locate the hole on each side of the shutter panel. Inside the hole is a screw called the “tension screw.” 2) Using a Philips head screwdriver, turn the screw ¼ turn to the right to tighten the louvers or ¼ turn to the left to loosen them.

What do you do if your windows are too close for shutters?

1. Attach a large (double size) shutter, the size of the window on each end.
2. Mount double shutters at each end. …
3. Mount four shutters in the manner you would normally if the window were not Ganged.

Are shutters out of style 2021?

Window Treatment Styles And Designs That Are Out in 2021 Speaking of shutters, gray and gray-tone wood grain is rising in popularity for shutters, with all-white and dark wood shutter stains declining in popularity.

Are outdoor shutters in Style 2020?

They allow light and air and also offer protection from storms and are a great choice for homes in tropical regions. So, when the question ‘are exterior shutters still in style’ comes to your mind, the answer is ‘Yes‘. No other exterior decorative elements can beat the flexibility and smoothness of these shutters.

Why are shutters so expensive?

Why are they so expensive? Plantation Shutters are labour intensive. To make a quality Plantation Shutter there are a number of steps to assemble it to your exact measurements, use quality material and paint with quality paint.

Should shutters be taller than the window?

Shutter Width The height of window shutters you should order is generally the actual height of the opening not counting the sill should you have one; however, many customers prefer to have the panels a little taller than the actual opening height.

Can you paint vinyl shutters?

Yes, you can repaint plastic or vinyl shutters. … Rinse off the soap with a hose, and allow the shutters to dry before painting. When painting plastic or vinyl, use a high quality, exterior, acrylic latex paint or a paint made specifically for plastic.

Can you open windows if you have shutters?

A common question or concern is how windows work when you’ve got shutters installed. … For windows that crank out or windows that tilt in for cleaning, you can absolutely still open and operate your windows, but it will be important to select the correct type of mount for your shutters to avoid blocking these functions.