The top of the spring retainer is plastic & you use a ½ inch ratchet extension to remove it. You can also use a pair of needle nose pliers with the tips spread apart, turn counter clockwise. After removing the spring & retainer pull the upper auger section off & you will have access to the agitate dogs.

How do you remove an agitator without a bolt?

The top of the spring retainer is plastic & you use a ½ inch ratchet extension to remove it. You can also use a pair of needle nose pliers with the tips spread apart, turn counter clockwise. After removing the spring & retainer pull the upper auger section off & you will have access to the agitate dogs.

How do you get a stuck agitator out of a washing machine?

ANSWER: To remove a tightly-fitted agitator or one that has become firmly glued in place by soap residue, first unplug the washer and remove the agitator cap. Then, if there is room between the bottom edge of the agitator and the tub bottom, work a completely deflated bicycle tire in underneath the agitator.

Do washers have removable agitators?

The industry-first 2-in-1 removable agitator lets you customize any load to care for your clothes the way you want by easily swapping the agitator post in or out. With two ways to wash, it’s twice the washer you have at home.

How do you remove a Cabrio agitator?

Reach into the tub and remove the metal cap in the center of the agitator, covering the bolt securing the agitator to the drive shaft. Use a 7/16 inch socket wrench and extension to undo the agitator bolt in a counterclockwise direction; do not remove the bolt and washer.

Why have a removable agitator in a washer?

Agitators can take on tough loads, without being tough on clothes. … When more space is needed, easily remove the agitator to create an impeller washer that will allow for more room in the washer basket for bulkier articles.

Can the agitator be replaced?

There are gaskets and seals around the agitator shaft and inside the agitator that can only be replaced after the agitator is removed. Other repairs, such as replacing a tub bearing, drive block or wash tub, require removing the agitator before the real repairs can begin.

How do I know if my agitator is broken?

The agitator should start to oscillate back and forth, mixing up the clothes in the water. If the agitator does not move, double check that the sensor is depressed. If it still does not move with the sensor depressed, the agitator is broken and should be repaired.

Do top load washers clean well without agitators?

A top-loader’s twisting wash motion (with or without an agitator) isn’t as effective as a front-loader’s tumbling wash. Just make sure to get a high-efficiency model. They clean better than agitator-style models, using much less water and energy, and are gentler on clothes.

How do you remove the agitator from a Maytag Centennial washer?

1. Unplug the appliance. …
2. Lift the lid.
3. Remove the fabric softener dispenser. …
4. Loosen the agitator. …
5. Remove the agitator completely. …
6. Put the bolt in position before putting the agitator in the machine. …
7. Assemble the agitator.

Article first time published on

How do you get a stuck agitator out of a Kenmore washing machine?

1. Turn off your washer and unplug it from the wall. Lift up the hood to reveal the washer tub and agitator.
2. Remove the agitator cap. Depending on your Kenmore model, this can be done in one of two ways. …
3. Remove the agitator bolt. …
4. Put on the safety gloves.