Gently pry back the silicone/rubber trim ring that surrounds the woofer. … Once the trim ring is removed, begin removing the screws from the perimeter of the woofer using a 3mm hex key head.With the screws removed, the woofer should come free and pull out toward you.

Can a speaker cone be replaced?

Speaker cone repair Sometimes it can be possible to obtain and fit replacement cones. If no other method is available one last ditch method to save and repair the loudspeaker that has worked well in the past uses a small patch. Most speaker cones are made of paper, and so a repair using some tissue paper works well.

Can you fix a blown sub?

To fix your blown subwoofer you’ll need to take it out of your car, fix or replace any damaged parts, and glue/wire it back together. This process can range from easy to very difficult, depending on the problem.

Can you remove a speaker cone?

If you tear or crease the speaker cone, the party’s over! Around the rim of the basket there may be a plastic or cardboard ring over the foam edge. This must be removed. Use your putty knife or screwdriver to gently pry it away.

How do I know if my subs are blown?

Subwoofers are blown when they either receive too much power or too much of a distorted signal. You can find out if your subwoofer is blown by listening to the sound, reviewing the movement of the woofer, and using a multimeter to find out if the coil is blown.

How do you replace Speaker membranes?

1. Remove the masking tape from the air gap on the magnet’s voice coil.
2. Set the new cone in the air gap. …
3. Remove the cone and apply adhesive. …
4. Carefully place the cone in the gap and apply a small amount of pressure.
5. Insert shims into the air gap in the voice coil to center the speaker.

Why did my subwoofer started smoking?

Clipped, unclipped, dirty, clean, it doesn’t really matter how the power goes into the woofer, it is going to cause the voice coil to heat up. … Both the smoke and the smell are a result of those resins on the coil returning to liquid and eventually a vapor.

Can I take apart a speaker?

Speakers With No Screws On The Outer Case You can often pry these speakers open with a thin blade, but there’s another way to take them apart. Use a screwdriver to loosen (but don’t remove) the speaker’s terminals. Then, insert guitar picks between the speaker cone and the magnet. Don’t use paper picks; they’ll break.

What is the dust cap on a speaker?

The dust cap (also known as dust dome, or dome) is a gently curved dome mounted either in concave or convex orientation over the central hole of most loudspeaker diaphragms. It protects the inner mechanics (such as the pole pieces and the voice coil) from small particles (which can cause rubs) and other contamination.

How do you disassemble a speaker?

1. Remove the speaker from the enclosure. …
2. Remove the grilles from the speaker. …
3. Take off the outer foam or rubber ring by prying it off with the putty knife.
4. Pry off the cone with the putty knife.
5. Pry the bottom section of the cone out of the metal plate.

Article first time published on

Can you change the speaker in a subwoofer?

If you want to convert this speaker into a subwoofer, you will need to remove the tweeter and also the cross-over, which is a circuit that is designed to split the signal into high frequency and low frequency signals. You then have to cover the hole where the tweeter is supposed to be.

How can you tell if a speaker cone is blown?

A blown speaker can have damage that can be heard with some mechanical movement. If you gently tap on the cone of the speaker it should have a firm drum like sound. If you hear a rattling sound (like a loose snare drum), this is an indicator of a bad speaker.

Is it bad to touch speaker cones?

If you touch the cone during operation you are likely not to do this symmetrically, so the movement isn’t straight any more and the windings of the coil can rub against the magnet and possibly get damaged or deteriorated. Not generally, as long as little force is used.

Which glue is best for speaker repair?

Glue silicone with silicone. Specifically, silicone glue or silicone caulk will work best.

What does a blown Sub sound like?

Listening to the sound First, reduce the sound to a low volume and commence audio playback. Increase the volume and bass slowly, all the while paying extra attention to the sound. If it is distorted, you subwoofer is partially blown subwoofer and if there is no sound at all, it is definitely completely blown.

Why do my subwoofers pop?

Subwoofers make popping noises because of squared waveforms, incorrect cone signals, or overpowered setups. The distorted sounds indicate a mismatch between the input and output based on the speaker’s specs. Loose wiring can also cause popping noises.

What causes a subwoofer to stop working?

Short Circuit. The most common cause of speaker failure is short-circuiting. A short circuit in the wires providing the signal will prevent the signal from ever reaching the subwoofer. A short circuit at the terminals on the subwoofer will also prevent electrical current and signal from reaching the subwoofer.

Can subwoofers damage your alternator?

Subwoofers on their own cannot damage your alternator. However, subwoofers combined with their amplifier and the corresponding amplifier can damage your alternator if it draws too much power from your battery. And this can cause the alternator to overheat and potentially damage.

Why does my subwoofer sound like rattling?

Subwoofers often rattle when there are loose components, but it they can also rattle if they are underpowered or overpowered. It’s important that you do an inspection on your subwoofers before each and every performance. Subwoofers are crucial devices for your home theatre system.

How long does a subwoofer last?

There are a lot of variables that will impact how long your equipment lasts, but in general a good sub can last for 20+ years.

Why does my speaker smell like it's burning?

Some speaker voice coils will give off a particular smell if you warm them up enough while playing at high volumes. This may happen more often with new speakers, but also may indicate that you are clipping the amplifier (even if you think you can’t hear it). Clipped power warms up speakers fast.

Why are my subs getting hot?

When clipping is present the subwoofer moves less than normal due to the plateaus in the waveform and in turn causes excess heat to build up. Over time this excess heat causes the voice coil to break down and eventually fail.

How do voice coils burn out?

Instead, the Fast Burn is when the windings rub and bang against each other. As the resins melt, they do so more evenly than the Rattle. Gases are allowed to escape from the inner layers of the voice coil, you may even notice small resin bubbles form on the gaps between the windings as the resin boils.

Should you keep dust covers on speakers?

If you have young children, feisty pets, or a clumsy uncle who stops by a lot, I would highly recommend leaving the grilles on your speaker unless you want to have an unplanned repair. Grilles also act as dust covers to help keep the drivers clean.