Measure the length and width of the roof surface. … Unroll the roofing material on the ground to relax some of the curl out of it.Thoroughly clean dirt from the roof with a broom. … Use roofing cement to adhere the roof drip edge to bottom edge of roof deck.

Can you roof over rolled roofing?

Rolled roofing is very adaptable and can be cut into 12-inch by 36-inch strips to act as hips and ridges or 9-inch strips for eaves and rakes. If removing your current shingles is a problem, it is usually permissible to re-roof over your existing roof with rolled roofing.

How do you nail down rolled roofing?

Do you nail down roll roofing? Nails are typically used to secure this type of roof. You can nail the separate layers by hammering the nails in 10-inch intervals across the roof. After that, you’ll want to use cement to cover them and seal them in place.

Do you need underlayment for rolled roofing?

Q: Should I underlay my roll roofing? It depends on your budget, but installing an underlay is not out of necessity but preference. While roll roof underlay is not costly, they offer some layers of protection. Make sure you nail down the underlay and then roll it, making sure it is both smooth and flat.

How long does rolled roofing last?

The average lifespan of asphalt roll roofing is 5 to 10 years. With proper maintenance, you can expect to get the maximum life from your asphalt roll roof.

Can roll roofing be installed vertically?

Tips for Installing Roll Roofing On high-pitched roofs, install the roll roofing vertically; lower sloped roofs allow for an easier horizontal installation. It’s not recommended to install roll roofing when the temperature is below 45 degrees Fahrenheit.

Is peel and stick underlayment worth it?

In areas prone to strong wind and rain, peel and stick underlayment is always a better choice compared to traditional solutions like asphalt. Peel and stick is significantly more efficient in minimizing the risk of water infiltration and damage.

Is a drip edge necessary on a roof?

Without a drip edge, water may end up beneath the shingles and may cause damage to various parts of the home. Though your home may not have originally had a drip edge installed, drip edges are now required by most building codes across North America to protect homes from damage.

What goes first drip edge or ice and water?

The best way is to install the roof drip edge only along the eaves first, then place ice-and-water barrier (in the snowbelt) or felt paper (underlayment) over the drip edge. This lets any water that gets on the roof run down the underlayment and over the drip edge.

Should drip edge be tight to fascia?

A vertical drip edge lip extends down roughly 1 5/8″ and as Steve points out, should not be set tight against the fascia board or water may run behind the gutter and down the fascia, inviting leaks and rot.

Article first time published on

Is rolled roofing bad?

Drawbacks. Homeowners are advised to install rolled roofing during warmer weather conditions. Naturally, almost any building material will expand if exposed to higher temperatures. Rolled roofing is not an exemption to this and will usually buckle if installed under the wrong conditions.

What types of roll roofing are there?

• Rubber: This is one of the least expensive roll roofing options. …
• Asphalt: This roofing has an oil-based, mineral surface. …
• EPDM Roofing: …
• TPO: …
• Bitumen Roofing: …
• Pros. …
• Cons.

What is roll roofing made of?

Asphalt roll roofing or membrane is a roofing material commonly used for buildings that feature a low sloped roof pitch in North America. The material is based on the same materials used in asphalt shingles; an organic felt or fiberglass mat, saturated with asphalt, and faced with granular stone aggregate.

How long does GAF Liberty last?

LIBERTY™ SBS Self-Adhering Cap Sheet is a granule-surfaced roofing membrane designed to be used with LIBERTY™ SBS Self-Adhering Base/Ply or LIBERTY™ MA Mechanically-Attached Base Sheet to provide long-lasting protection for the low-slope areas of your property. System guarantees are available for up to 20 years.

How long is peel and stick underlayment exposed?

Plystick Plus, our peel-and-stick underlayment, can be left exposed for up to six months.

Do you put felt under peel and stick roofing?

Without proper underlayment, shingles, shakes and other roofing materials can’t live up to their full potential. Roofing felt paper is a common underlayment, but adhesive-backed underlayment membranes may offer more protection.

What pitch is needed for roll roofing?

The minimum slope requirement for mineral-covered roll roofing material is half an inch per foot (4 percent). Organic roll roofing can be installed on roofs with a minimum slope of 1 inch and, while asphalt roll roofing can be installed on a 2-inch slope in an emergency, a minimum slope of 3 inches is recommended.

What is the minimum slope for a metal roof?

For metal panel roof systems with nonsoldered seams with applied lap sealant, IBC 2018 prescribes a 1/2:12 minimum roof slope. For standing-seam metal roof panel systems, a 1/4:12 minimum roof slope is prescribed.

Does drip edge go over or under felt?

Does Drip Edge Go Over or Under Felt? According to most building codes and manufacturer recommendations, the drip edge should be installed beneath the underlayment along the eaves of the roof.

Where does ice and water shield go on a roof?

How Should Ice and Water Protector be Installed on a Roof? Ice and water protector needs to be installed directly onto the roof deck after you have placed the drip edge at the eave. (The drip edge will be installed over the ice and water protector and other underlayments at roof rake edges.)

Can you install drip edge after roof?

The drip edge is often replaced when new shingles are installed, but it can be replaced at any time. Asphalt roof shingles can become brittle in cold weather, so wait until a warm (but not hot) day to remove and replace eave stripping.

How much does it cost to install drip edge?

The standard drip edge used (aluminum) is going to be around $2.00 a linear foot, including labor to install. If you upgrade to a different metal (steel or copper), it’s going to cost even more.

How far should shingles hang over the drip edge?

Shingles should not extend more than 3/4” (19 mm) past the drip edge. If shingles overhang the edge of the roof by more than 3/4” (19 mm), then they are not supported and may crack and break off. In addition, the wind resistance at the roof edge may be compromised.

Why does water run behind my gutters?

Water Gets Behind the Gutter If water is dripping behind your gutter, it’s probably because it was installed without any flashing over the back of the gutter. The gutter apron will prevent the dripping. A gutter apron is a bent piece of flashing that tucks up under the shingles and over the gutter.

Is roll roofing waterproof?

Waterproofing: Rolled roofs can easily provide protection from water for up to 10 years.

Is shingles better than roll roofing?

Roll roofing has a typical life span of 5 to 8 years. Shingles have an expected life of at least 20 years, and the better grades can carry warranties of 30 to 50 years. Shingles are less likely to crack when exposed to sunlight and rain, and most shingles will fare better when subjected to hail than roll roofing will.