Firmly hold the neck of the strimmer with your left hand and the pull start assembly with your right. The strimmer should start within 3-5 pulls on a new or cold engine. Slowly pull the starting rope with your right hand until you feel the resistance of the rope.

What is the choke on a trimmer?

The choke is a valve on the engine’s air intake that reduces the volume of air flowing into the engine on a cold start. … Once the engine has warmed, you open the choke valve to return the fuel/air mixture to the normal proportion.

Why is my Troy Bilt mower not starting?

It may sound simple, but if your mower will not start, try turning off the mower blades or PTO shaft, set the brake, and try starting it again. The parking brake must always be fully engaged when starting. Next, check the fuel level in the tank, and be sure to always use fresh fuel if the tank is low.

What size is the Troy Bilt JumpStart bit?

This item Troy-Bilt Drill Bit JumpStart for Trimmers & Other Handheld EquipmentTroy-Bilt 17 in. Gas String TrimmerSold ByOff The Map SalesRon’s Home and HardwareItem Dimensions6.3 x 5.3 x 6.3 inches12.38 x 11.25 x 41.75 inchesItem Weight2.40 ounces13.95 lbsSizePack of 1—

Why is my trimmer not working?

It is possible that your Trimmer does not turn on or move because it is dirty. There can be hair or dirt particles stuck inside it, causing the cutting unit to be blocked. To fix this problem, properly clean your Trimmer. Remove the cutting unit and clean your Trimmer from the inside as well.

Why has my strimmer stopped working?

The most common problem with a string trimmer is that the unit runs out of string. The string may also be twisted or loose on the spool. … The trimmer may need lubrication and cooling fins or air passages may be blocked. A cordless trimmer’s battery or charger may be faulty.

Why does my trimmer dies when I give it gas?

One reason why one of these trimmers may die at full throttle is that too much oil is in the gas, which causes poor combustion. Improper operation, including overuse of the choke, can also be responsible. Poor combustion produces carbon deposits that foul the spark plug and exhaust port, making the problem worse.

Why does my hedge trimmer keep cutting out?

A clogged carburetor is most commonly caused by leaving fuel in the hedge trimmer for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall or run roughly.

How do you start a flooded hedge trimmer?

With the unit resting on the ground, squeeze the throttle trigger to wide open throttle or fast position. At the same time the trigger is depressed, pull the starter rope several times, 10 to 15 times back to back. (Flooded engine will usually only take 6 to 8 pulls to get engine started.)