Press the rubber primer bulb on the side of the mower engine three times. … Pull and hold the safety bar near the top of the handle. … Grip the handle of the starter rope and pull with a rapid movement. … Place the ignition key in the keyhole on the Toro lawn mower.

What would cause a Toro Zero Turn not to start?

A zero turn lawn mower won’t start because of a fuel restriction caused by clogged or failing fuel components; an air restriction caused by a plugged air filter; or an electrical problem caused by a bad battery, loose connections, faulty electrical components or faulty charging system.

Why does my Toro riding lawn mower not start?

Clean the fuel filter and check for adequate flow from the fuel lines. Clean or replace the air filter. Clean or replace the spark plug, making sure the spark plug gap is correctly set (specific gap may be found in the user manual). Make sure the spark plug wire is firmly attached to the spark plug.

How do you start a Toro lawn mower?

1. Press the rubber primer bulb on the side of the mower engine three times. …
2. Pull and hold the safety bar near the top of the handle. …
3. Grip the handle of the starter rope and pull with a rapid movement. …
4. Place the ignition key in the keyhole on the Toro lawn mower.

Why is my lawn mower turning over but not starting?

The most common reason for a riding mower cranking over but not starting is bad gas, but other possible reasons include: Gas Valve Off. No Gas. Choke Fault.

How does electric start mower work?

Electric-start mowers have no crank cord. An electric start lawn uses an electric starter rather than a manual crank cord to initially turn the engine. … The electric starter is driven by a small electric motor actuated by a solenoid that cranks the flywheel, which then begins the process of ignition.

How do you keep a zero turn straight?

Pushing both of the control levers will move your zero turn mower in a straight line. Pushing one control lever farther forward than the other will cause you to turn in the opposite direction. So pushing the right control lever farther forward than the left will cause you to turn to the left.

How do I start my lawn mower with a choke?

Open the choke all the way if you notice that it has been closed. If it has been open, the carburetor may be flooded. Close the choke, and pull the starting cord a few times. When you get the engine to sputter, open the choke, and try starting the mower.

Where is the choke lever on a lawn mower?

There’s a variety of lawn mowers, but for an internal combustion engine, the choke valve is usually located on the body of the engine or a lever on the handle. Most choke valves are butterfly valves mounted in the manifold up from the carburetor jet.

Where is carburetor on Toro lawn mower?

A mower carburetor is located behind the air filter on the side of the engine, opposite side to the muffler. In this post, you’ll learn how to locate and identify your lawn mower carburetor and your mower air filter.

Article first time published on

Where is the spark plug on a mower?

Spark plugs are typically located on the back or side of a lawn mower engine. Look for a short wire that’s about 1/4-in. -thick leading to the top of a short, cylindrical protrusion from the engine. If you’re not sure where the spark plug is, consult your owner’s manual.

Where is the spark plug on a riding lawn mower?

Locate the spark plug(s). On a walk-behind or riding lawn mower, they’re usually near the front of the engine. On zero-turns, look near the back of the engine on the sides. Disconnect the spark plug lead and clean around the spark plug to remove any debris.

How do you manually move a Toro Zero Turn mower?

1. Step 1: Park the Mower.
2. Step 2: Turn Off Engine.
3. Step 3: Lock the Bypass Levers.
4. Step 4: Turn on Ignition Key.
5. Step 5: Wrap Up.

How long does it take to learn to drive a zero turn mower?

Spend as little as 30 minutes in an open grass area to learn how a zero turn mower functions and you’ll be a pro.

Is it hard to drive a zero turn mower?

Zero-turn mowers look a lot different than traditional riding mowers. You control the steering with levers on each side, rather than a steering wheel. While zero-turn mowers may look challenging to drive, they’re really very easy. The advantages are speed, responsive control, and tight turning radius.

How do you start a cold riding lawn mower?

1. Brush the tip of the spark plug with the wire brush to remove any carbon and oil debris. Spray the tip with starter fluid. …
2. Press the primer button near the air filter cover three times with you thumb. Take your thumb off and allow the primer button to raise back out. …
3. Start your lawn mower.

How do you start a riding lawn mower after winter?

1. Check the oil before you start a four-cycle mower that has been sitting for a long time. …
2. Prime the engine by pushing the priming bulb three times. …
3. Give the spark plug wire a little tug to see if it’s loose.

How do you start a riding lawn mower without a starter?

Attach a jumper cable from the large lug where the engine starter cable and other lugs connect to the battery cable. Finally, rotate the ignition keys of the lawn mower. If it just clicks without starting the lawn mower, you may need to replace the solenoid.

Where do you jack up a riding lawn mower?

Center the floor jack with the front or rear of the riding mower tractor. Roll the floor jack directly underneath the front or rear axle. Twist the floor jack handle clockwise to tighten the hydraulic valve, allowing the floor jack to be raised.