Miter Protractors are ideal for carpenters, plumbers and all building trades that require the measuring and transferring of angles. Miter Protractors take error-prone calculations out of the process of miter cuts. Miter cut scale transfers readings directly to the miter saw for miter joints.

What is a Mitre protractor?

Miter Protractors are ideal for carpenters, plumbers and all building trades that require the measuring and transferring of angles. Miter Protractors take error-prone calculations out of the process of miter cuts. Miter cut scale transfers readings directly to the miter saw for miter joints.

Do you push or pull a sliding miter saw?

Sliding miter saws are designed to cut on the push stroke. Pulling a miter saw through the cut results in a climb cut that could cause the blade to rise up out of the wood and chase after you. Also, it is important to use a blade with teeth that angle forward between 0° and 5°.

How do you use a wood protractor?

Using a protractor, swing the blade until the desired angle between the handle of the bevel and the blade matches the angle you want. Use a protractor to check the angle. Tighten the wing nut to lock the angle in place. Lay the T-bevel on your working surface.

How do you use a digital protractor?

To operate the DIGITAL PROTRACTOR, press the ON/OFF button; it will begin displaying angle readings immediately. Set the DIGITAL PROTRACTOR on the surface to be measured and read the angle. To get the most accurate reading, allow the DIGITAL PROTRACTOR to settle for 5 seconds before noting the angle.

How do I calculate the angle I need to cut?

The formula involves dividing 360 by the number of sides to calculate the corner angle. Then divide it by two to get the miter angle. If you’re making a five-sided project with all sides equal, you divide 360 by five to get 72 degrees. So each joint or corner forms a 72-degree angle.

Why are my miter cuts off?

Usually if you still can’t get the miter joint to close perfectly, it’s because you either cut one piece too long (or too short), or the blade itself was not perpindicular (90 degrees) from the base.

How do you calibrate a mini protractor?

Put the unit’s working surface on one surface, press “Calibrate” button, “0.00°” is displayed. Then move the unit to other surface to be measured, the displayed value will be the included angle of the two surfaces. Press “Calibrate” button for 3-5 minutes, it wilt change to the state of absolute measurement.

What is the tool to measure angles?

protractor, any of a group of instruments used to construct and measure plane angles. The simplest protractor comprises a semicircular disk graduated in degrees—from 0° to 180°.

Is there a protractor app?

Protractor helps you to measure angles quickly and easily. This app turn your iPhone into a handy pocket protractor that can measure angles in both degrees and radians.

Article first time published on

Why is my miter saw burning the wood?

A dull blade will make it hard to cut quickly, and the slower the feed rate of the saw, the more friction against the wood and the greater the likelihood of scorch marks. Pushing the stock through the saw too slowly is a common cause of saw blade burn. Sometimes a blade that feels dull might only be dirty.